-40%
ARLAYER
Separate tone, transients and air independently
ZAR 71.99 ZAR 119.99
ELEK
Split a track into vocals, drums, bass and other, remove the vocal, or read tempo and key. Runs on your computer; stems come back as 24-bit WAV for your DAW.
Stems, vocal removal, key and tempo
ZAR 149.99 ZAR 499.99
-70%ELEK
Split a track into vocals, drums, bass and other, remove the vocal, or read tempo and key. Runs on your computer; stems come back as 24-bit WAV for your DAW.
Stems, vocal removal, key and tempo
ZAR 149.99 ZAR 499.99
-70%Previews
Load ELEK on a track in your DAW and choose what to do: nothing runs until you pick an operation. Separation uses HT-Demucs over overlapping windows, and the instrumental is the mix minus the vocal, so nothing is lost between the two. Every run gets its own folder in Music/ELEK. The mixer plays the stems together; click a waveform to jump, and drag a stem straight onto a track. Measured on an Apple M2 with 8 GB of memory: a four-minute track splits into four stems in about three and a half minutes; tempo and key take a few seconds. The separation model is inside the plug-in, so nothing is downloaded after install and no account is needed. Requirements: macOS 11 or later, Apple Silicon and Intel (VST3, AU); Windows 10 or later, 64-bit (VST3).
What ELEK offers
Stem separation writes vocals, drums, bass and other, each as its own 24-bit WAV file.
Vocal removal writes the vocal and the instrumental; Key & BPM reads a track in seconds.
Overlapping windows with a cross-fade, so the stems have no clicks where the windows meet.
Reads WAV, AIFF, MP3 and FLAC at any sample rate; stems line up with the original to the sample.
Play, mute, solo and set each stem's level, then drag its waveform onto a track in your DAW.
Files are named with track, stem, tempo and key; earlier separations reopen with one click.
What’s new
- First release on MuseHub.
1.0.3
FAQ
Reviews
Not enough reviews yet
